Electrolux Rapido ZB4112, Руководство пользователя

Страница: 7 / 12

Before you start …check the
voltage
Before connecting the
cleaner to an electrical
supply ensure that voltage
marked on the data plate
(on the underside of
cleaner) is correct for your
electrical supply. If is not,
do not use the cleaner but
refer back to your dealer.
ELECTRICAL SUPPLY INSTRUCTIONS
Connecting to your electrical supply
Permanently connected to the cleaner is a mains supply (2-core)
cable fitted with a non-rewirable plug incorporating a 13A fuse. In
the event of the fuse requiring replacement the fuse cover
should be removed using a small screwdriver. The old fuse
MUST be replaced by a 13A ASTA approved BS1362 fuse and
the fuse cover must be replaced before the plus is used again.
In the event of loss of the fuse cover, replacements can be
obtained from your Electrolux dealer or Electricity Board and
must be of the same colour as indicated by the coloured insert
on the base plug.
If difficulty is experienced in obtaining a replacement, contact your
nearest Electrolux Service Centre. (Please see the separate
Electrolux Service Organisation leaflet).
In no circumstances must the plug be used without a correct fuse cover fitted.
If the plug that is fitted to your appliance is not suitable for your
socket outlet, it must be cut off and the appropriate plug fitted.
Remove the fuse from the cut off plug. The cut off plug should
then be disposed of to prevent hazard of shocks in case it
should be plugged into a 13 Amp socket in another part of your
home.
The wires in the mains cable of this appliance are coloured in accordance with
the following code:
Blue: Neutral.
Brown: Live.
As the colours of the wires in the mains cable of this appliance may
not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured blue must be connected to the
terminal which marked with the letter N or coloured black. The
wire which is coloured brown must be connected to the terminal
which is marked the letter L or coloured red.
If using a three-pin plug, do not make any connection to the
terminal marked with the letter E or by the earth symbol or
coloured green or green-and-yellow. [This cleaner is double
insulated and no earth-connection is necessary.]
It is in your interest to ensure that the plug is correctly attached
to the mains cable. In case of doubt, have it done by a qualified
electrician, as Electrolux cannot regard the repair of faults on the
plug connection as a service that can be given free of charge
under the terms of guarantee.
As a general guide to fitting any plug
• Ensure the lengths of wire inside the plug are prepared correctly.
• Connection should be firmly made after all conductor stands are
entered into the terminal posts.
• When preparing the cable ends take care not to damage the
outer seal, or insulation surrounding the inner conductors.
• Tighten all screws.
• Replace the top cover of the plug and secure.
6