76
B.2.7 Reversing opening of half doors
ATTENTION
Disconnect the appliance
from the power supply be-
fore carrying out the door
reversing procedure.
The refrigerated cupboards are normally supplied with right
opening.
When changing to left opening, proceed as follows:
open the control panel, loosening the 2 screws located be-
tween the panel and door;
`
`
remove the cap located on the left side and refit it on the
right side of the control panel;
`
`
undo the 2 screws of the upper bracket “
A
”, the hinge fas-
tening screw “
B
” and the 2 fixing screws (
Detail 1
);
`
`
remove the cap “
C
” from the left side and place it on the
right side (
Detail 2
);
`
`
remove the door, pull out the hinge from its seat, move it
from the right to the left and fit it in the hole as shown in
the figure (
Detail 3
);
`
`
remove the middle bracket “
D
” and fix it on the opposite
side of the cabinet (
Detail 4
)
`
`
remove the bottom hinge “
E
” and the lower bracket “
F
”
from their seats and refit them in the special seats on the
opposite side (
Detail 5
);
`
`
position the bottom door on the bottom hinge “
E
”;
`
`
fix the middle bracket “
D
”;
`
`
position the top door on the middle bracket “
D
”;
`
`
position the upper bracket “
A
” between the door and the
roof of the appliance, tightening the fixing screws;
`
`
before tightening the screws, align the door with the cabinet
panel, adjusting the lower and upper brackets and making
sure the seal is perfectly fitted on all sides;
`
`
then tighten the bracket fixing screws.
`
`
close the control panel again, securing the 2 screws (previ-
ously loosened) between the panel and door.
B
A
Detail 1
2
3
1
C
Detail 2
D
Detail 4
Detail 5
E
F
2
3
1
Detail 3
