9
Mounting under a continuous worktop
If installed under a continuous
worktop, the appliance is fastened
with a mounting screw (A) under the
panel.
Rehingeing the door
The side at which the door opens can be changed from the right side
(as supplied) to the left side, if the installation site requires.
Warning!
When changing the side at which the door opens, the appli-
ance may not be connected to the mains. Remove plug from the
mains beforehand.
Tilt the appliance slightly towards the
rear and prop it securely.
Unscrew the door hinge screws (K)
and take the door bearing (1) down
wards out of its cavity.
Open the door a little way and take it
out downwards.
Unscrew the upper pin (A) and screw
it into place on the opposite side.
Fit the door into the upper pin (A)
and close it.
Insert the pin of the door bearing (1)
into the left hand cavity and
screw the bearing firmly into place
with the screws (K).
☞
☞
☞
☞
☞
☞
AEG96
A
AEG97
K
1
AEG98
A
12
