18
Getting Started
befoRe settinG oven contRols
Removing and Replacing oven Racks
AlwAys ArrAnge oven rAcks
when The oven is cool (Prior
To oPerATing The oven).
Always
use oven mitts when using the oven.
To remove an oven rack
, pull the rack
forward. Lift up the rack off the oven
rack slider.
To replace an oven rack
,
place the rack on the slider into the 4
pinholes located at the 4 corners of the
rack.
oven vent location
The oven is vented
under upper
control panel
. When the oven is on,
warm air is released through the vent.
This venting is necessary for proper
air circulation in the oven and good
baking results.
Installed on sliders
To remove from
sliders
To place on sliders
Pull oven rack
forward and lift it
up of the oven rack
slider.
Oven vent
Always arrange the oven racks when the oven is cool (prior to operating the oven). Always use
oven mitts when using the oven.
Removing non-sliding oven Racks
Simply pull the rack and slightly tilt it upward when the rack hits its stop position.
Replacing non-sliding oven Racks
Insert the rack into the oven rack supports by inserting the rack openings into the rack sup
-
ports. Be sure the rack is at the same position on each oven rack support on both sides.
Insert the openings
into the rack support
installing oven Rack supports
AlwAys insTAll oven rAck
suPPorT before Turning
on The oven (when The
oven is cool).
To remove the
oven rack supports
for a self-
clean cycle, (36” range: remove
36” Range Only
Remove
Replace
Oven Rack Sup
-
port Screw
Oven Rack Sup
-
port Bracket
the screw located over the rack support on each side) pull up the
support from the oven rack support brackets to disengage supports
from the oven. If the rack supports are not removed, the self-clean
cycle won’t start. Always remove the left side support first.
To install oven rack
supports
insert the rack supports into the rack support brackets on the oven side
as shown (36” range: put back screws at their original location).
