Electrolux ICON E36IC75FSS, Руководство по обслуживанию

Страница: 25 / 37

Page 25
COMPONENT ACCESS AND SERVICE PROCEDURES
To remove and replace the power generator
boards begin by removing the heat sink thermal
cut out. Next remove the two metal clips that
clamp the heat sinks together (if present). Gently
pry the clip off with a small screwdriver. (Fig. 25)
Fig. 25
Fig. 25C
Black &
Blue wires
Torx
Screw
Torx
Screw
Replacing The Induction Generator Power Board
To unplug the fl at cable connector on the fi lter
board and the power generator board (Fig. 25A)
use the special cable removal tool.
Fig. 25A
Flat Cable
Connector
Cable Removal
Tool
The tool is packaged with
each power board and
fi lter
board as well as with the
replacement cable.
Grip the connector with the tool as shown in the
photo and pull up to release the connector (Fig
25B).
Pull Up On
Tool
Fig. 25B
Unplug the Blue and Black wires from the power
generator board terminals X1 & X2. When
reconnecting these wires terminal polarity is not
important. Remove the two torx screws that mount
the board to the outer case. (Fig. 25C).
Lift out the induction power generator board. (Fig.
25D)
Fig. 25D