What to do if…
34
Malfunction
Possible cause
Remedy
The cycle indicator for the se
lected dishwashing cycle is
flashing:
the control indicator
is
lit,
fault code
Å 10
is displayed
in the multidisplay
(Problems with water inlet).
Water tap is blocked with
limescale or faulty.
Check the water tap and have
it repaired if necessary.
The tap is turned off.
Turn the tap on.
The filter (where present) in the
threaded hose fitting on the
tap is blocked.
Clean the filter in the threaded
hose fitting.
Filters in the base of the wash
ing compartment are blocked.
Cancel the dishwashing cycle
(see chapter: Starting a dish
washing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing cy
cle again.
Water inflow hose
has not been correctly posi
tioned.
Check the position of the hose.
The cycle indicator for the se
lected dishwashing cycle is
flashing,
fault code
Å 20
is displayed
in the multidisplay
(there is water in the dish
washer’s internal dispenser).
The sink outlet is blocked.
Clean out sink outlet.
Water drain hose
has not been correctly posi
tioned.
Check the position of the hose.
Fault code
Å 30
is displayed
in the multidisplay.
The antiflood system has been
triggered.
First shut off the water tap,
then switch off the appliance
and contact the Customer Care
Department.
The control indicator
is lit.
The door of the dishwasher is
open.
Close the dishwasher door.
The control indicator
is lit.
The indicator
is there to re
mind you to check the dish
washer’s filters occasionally
and to clean them, if necessary.
It lights up at regular intervals,
regardless of how clean the fil
ters are.
The indicator goes out auto
matically at the start of the
next dishwashing cycle.
The cycle is not starting.
The mains plug is not
plugged in.
Plug in the mains plug.
A fuse in the house’s wiring
system is defective.
Replace the fuse.
For dishwasher models with a
delay start timer:
A start time has been selected.
If the dishes are to be washed
immediately, cancel the delay
start.