Electrolux F4TD, Инструкция по эксплуатации и обслуживанию

Страница: 12 / 56

12
1. Description of the ap-
pliance
The appliance described in this manual is
composed by a steam iron, connected to an electric
steam generator. The appliance can be used only
by adults. The appliance must be used only to
iron garments and linen. Any other usage is to be
considered improper and, therefore, potentially
harmful.
2. First usage
Unpack the appliance and make sure that the
follwoing items are included in the box: (refer to
Figure 2):
A. Iron
rest
B. Cable holder rod
C. Spring to hang the hose
D. Plastic
strip
E. Wooden rod for water level measurement
Dispose of cardboard and plastic according to the
recycling policy valid in your area.
Assemble the accessories as shown in Figure 2:
• Insert the spring (C) in the eye of the cable
holder rod (B)
• Insert the cable holder rod (B) into the hole in
the handle
• Tie the spring (C) to the hose (F) by means of
the plastic strip (D)
• Place the iron on the iron rest (A)
3. Usage
3.1. Setup
Refer to Figures 1 and 3.
• Unscrew the cap and fill the boiler with
approx. 1 liter of tap water. Do not spill water
out of the tunnel. (Figure 3.1)
WARNING - Do not place the machine
under running water: always use a sui-
table container to pour the water into the boi-
ler.
WARNING - Do not use distilled water
nor softening additives. Do not add per-
fumes to the water.
• Fill the boiler a little at a time, stop and check
water level with the wooden meter provided.
Make sure water level does not exceed the
maximum. (
Figure 3.2 )
• Close the cap manually. Do not close it too
tightly or with tools. Make sure the cap is
properly screwed otherwise you may notice
steam leaks.
• Insert the plug in a properly grounded outlet
(or into the socket built in the ironing table)
using the correct voltage. In most cases this
will be 230V 50 Hz.
WARNING - Do not use extension cords
or plug adapters.
WARNING - Do not use the machine if
the electrical plant is not properly groun-
ded.
• Turn on the iron and boiler switches. ( Figure
3.3 )
• While the machine is reaching working
temperature, set the iron thermostat to the
middle position (two dots). (
Figure 3.4 )
3.2. Ironing
• After turning on the machine wait about 10
minutes. When the steam lamp turns on the
machine is ready to start ironing. (
Figure 3.5 )
• Press the iron button to obtain steam ( Figure
3.6 ). When ironing at very low temperature
(one dot or less) do not use steam: water may
come out from the iron. On first steam call,
water droplets may come out of the iron: as a
precaution, direct the first steam jet towards a
waste cloth.
• Prior to starting ironing, set the iron temperature
to the suitable temperature for the fabric (see
maintenance tag on the garment). Do not
use a temperature higher than that advised
in the maintenance tag. Using too high a
temperature may result in permanent damage
to the fabric. Whenever increasing the iron
temperature, wait some minutes for the iron to
reach the temperature. Whenever decreasing
the iron temperature, wait some minutes for
the iron to cool off. Before ironing, try on a
hidden part of the garment: if the iron “sticks”
to the fabric or if the fabric turns yellow/brown,
decrease the temperature.
F4TD/1-ed3706
F4TD