5.
INSTALLATION
Fig. 8
Turn the heating power
knob to the COLD “ ”
position.
3.
Turn the temperature
control knob fully
clockwise to the Minimum
Water flow position.
4.
Fig. 7
Turn the heating power
selector spindle clockwise
until the flat section is on
the left hand side.
1.
Turn the stabiliser valve
spindle fully clockwise
until resistance is felt.
2.
Flat section to
left hand side
Stabiliser valve
3. Reassemble the water inlet cover.
4. Check to ensure that the wiring is not
trapped and replace the cover squarely to
the backplate and guide into position so that
the knobs locate correctly into the splined
spindles. Should any difficulty arise, recheck
the points above.
5. While applying slight pressure to the cover,
secure in position with the retaining screws.
6. Once you place the front cover on the
back cover properly fix the front cover with
the 4 screws.
15
ENGLISH
