Technical Support - DMM
26/106
599 77 23-65 Rev. 03
5.2.1.1
Control panel configuration
The washing programmes, the functions of the selector knob and the various buttons vary according
to the model, since these are determined by the configuration of the appliance.
5.2.1.2
Initial Start up
The first time the appliance is turned on and after every diagnostic cycle, the language and time need to be set.
5.2.1.2.1 Set Language
The first time the appliance is turned on or after a diagnostic cycle, the text line prompts you to turn the selector
to choose your language (the language displayed is the one of the silk screen printed control panel) for
approximately 3 seconds. Once you have chosen your language, after another 3 seconds you will be prompted
to touch the START/PAUSE sensor to confirm your choice.
If the appliance is turned off before you confirm your choice, the next time it is turned on, you will again be
prompted to choose your language.
5.2.1.2.2 Setting the time of day
After the language has been selected, the text line shows
“Time of day” prompting you to set the time.
After approximately 3 seconds, you will be prompted to turn the selector, which will change the time by an hour
(in the digits) every time it is moved. Once the correct time has been set, confirm by pressing the
START/PAUSE sensor.
The digits relating to the minutes start to flash. Again, turn the selector dial to adjust them too and confirm with
the START/PAUSE sensor. Now the time of day has also been set.
To change the language or time, see the key combination in the table below.
Language Configuration
Time Configuration
Once the appliance has been turned on during the
selecting phase you are given the opportunity to change
language.
Touch the sensors as shown in the figure, and for the
next 3 seconds you can choose your new language.
Once the appliance has been turned on during the
selecting phase you are given the opportunity to set
the time.
Touch the sensors as shown in the figure, and for the
next 3 seconds you can modify the time.
5.2.1.3
Programme selector (S1)
Description: see para. 3.2.2.1 on page 10
5.2.1.4
Programme configuration
Description: see para. 3.2.2.2 on page 10
