10 www.electrolux.com
Deep rinse ensures the fabric
softener is correctly dispensed
and thoroughly removed from
your clothes during rinsing.
3.5
DISPLAY
The display showns the following
information:
Machine In Pause Mode
You can tell when your washing
machine is in pause mode. The
time remaining is shown then “ ”.
Estimated time of the
selected program
After selecting a program, the
estimate time is displayed in hours
and minutes (for example 0.57).
The estimate time is calculated
automatically on the basis of the
maximum recommended load for
each type of fabric.
To start the selected program,
press the “Start/Pause” button.
If you have started your wash and
you wish to stop it for some reason,
press the “Start/Pause” button to
enter PAUSE mode
3.6
START/PAUSE BUTTON
After the program has started, the
time remaining is updated every
minute.
When the program is completed
the 3 zeros will flash.
End Of Program
In the event of operating problems,
some alarm codes can be
displayed, for example (see
“Troubleshooting” and
“Troubleshooting fault displays” on
page 25, 26, 27).
Alarm Codes
To restart the program from the
point at which it was interrupted,
press the “Start/Pause” again.
Incorrect Option Selection
If an option which is not compatible
with the set wash program is
selected, the display will show
“ ” and flashing with 3
consecutive short beeps
If lid is opened during
operation, the machine will
go into PAUSE mode. After
closing the lid press
Start/Pause button on
control panel to restart the
program.
