Electrolux EWFH 12280 W, Руководство пользователя

Страница: 8 / 28

Display
5.1:
• Duration of selected programme
After selecting a programme, the duration
is displayed in hours and minutes (for ex-
ample
2.05 ). The duration is calculated
automatically on the basis of the maximum
recommended load for each type of fabric.
After the programme has started, the time
remaining is updated every minute.
• Alarm codes
In the event of operating problems, some
alarm codes can be displayed, for example
E20 (see chapter «What to do if...»).
• End of programme
When the programme has finished three
blinking zeros
0.00 are displayed, the pilot
light ( 8.3 ) illuminates and the pilot light of
button 6 goes out. If there is not water left
in the tub (otherwise it is necessary to
empty it out), the door can be opened.
If your laundry is not removed within 10
minutes after the programme is finished,
the display switches off and the energy
saving system will be enabled.
Only the Start/Pause button pilot light is
flashing to indicate that the appliance has
to be switched off.
•
Incorrect option selection
If an option which is not compatible with
the set wash programme is selected, the
message
Err is displayed for a few sec-
onds and the red pilot light of button 6 light
starts blinking.
• Delay Start
The selected delay set by pressing the rel-
evant button appears on the display for a
few seconds. The delay time value decrea-
ses by one unit every hour. When only 1
hour remains, the time decreases every
minute.
5.2:
• Heating Phase
During the washing cycle the display
shows a temperature icon (5.2) to indicate
that the appliance has started the heating
phase of the water in the tub. 5.2
5.3:
• Child safety lock
This device permits you to leave the appli-
ance unsupervised without having the
worry that children might be injured by or
cause damage to the appliance. This func-
tion remains able also when the washing
machine is not working.
There are two different ways to set this op-
tion:
– before pressing button
6 : it will be im-
possible to start the machine;
– after having pressed the button 6 : it will
be impossible to change any other pro-
gramme or option.
To enable (disable) this option press simul-
taneously for about 6 seconds
3 and 4
buttons until the symbol 5.3 appears (dis-
appears) on the display.
Personalization
Acoustic signals
The machine is provided of an acoustic de-
vice, which sounds in the following cases:
• at the end of the cycle
• in the event of operating problems.
By pressing the
2 and 3 buttons simultane-
ously for about 6 seconds , the acoustic
signal is deactivated (except for the events of
operating problems). By pressing these 2
buttons again, the acoustic signal is reacti-
vated.
8 electrolux