Electrolux EWFH 12280 W, Руководство пользователя

Страница: 11 / 28

Important! The selected delay can be
changed only after selecting the washing
programme again.
The Delay Start
can not be selected with the
DRAIN programme.
Start the programme by pressing button
6
To start the selected programme, press the
button
6 , the corresponding green pilot light
stops blinking. The pilot light corresponding
to the running phase illuminates. The appli-
ance starts operating and the door is locked.
To interrupt a programme which is running,
press the button
6 : the corresponding green
pilot light starts blinking.
To restart the programme from the point at
which it was interrupted, press the button
6
again . If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the
red pilot
light of the button 6 blinks 3 times and the
message Err is displayed for a few seconds.
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out.
Before you make any change, you must
PAUSE the appliance by pressing the button
6 .
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
O and then to the new pro-
gramme position. Start the new programme
by pressing the button
6 again. The washing
water in the tub will be not emptied out.
Interrupting a programme
Press the button 6 to interrupt a programme
which is running, the corresponding green
pilot light starts blinking.
Press the button again to
restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to O to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you need
to open it, set first the machine to PAUSE by
pressing the button 6 . The door can be im-
mediately opened.
If the door remains locked, this means that
the machine is already heating or that the
water level is too high. In any case, do not try
to force the door!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to
O . After a few mi-
nutes the door can be opened (pay atten-
tion to the water level and tempera-
ture!)
.
After closing the door, it is necessary to se-
lect the programme and options again and
then to press button
6 .
At the end of the programme
The machine stops automatically. The pilot
light of button
6 , the pilot lights 8.1 and
8.2 go off. The light 8.3 illuminates.
If a programme or an option that ends with
water left in the tub has been selected, the
pilot light
8.3 is on to indicate that the cycle
is finished but the door is still locked. The
water must be emptied out before opening
the door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
O .
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 6 .
At the end of the programme, the light 8.3 is
on. The door can be now opened. Turn the
programme selector dial to
O to switch the
machine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleasant
smells.
Stand By: If your laundry is not removed
within 10 minutes after the programme is fin-
ished, the back light of the display switches
off and the energy saving system will be en-
abled. Only the pilot light of the button
6 is
blinking to indicate that the appliance has to
be switched off. By pressing any button the
appliance will come out from the energy sav-
ing status and you can set another pro-
gramme or switch the appliance off.
electrolux 11