13
BEFORE FIRST USE
4.
This setting permits you to either enable
or disable the buzzer at the end of the
program. As an example, you might wish
to disable this buzzer when you start a
wash when going to bed, so that when
the wash finished approximately 1 hour
later, it will not disturb you through the
night.
Error warning beeps such as
critical faults are not disabled.
Enabling/Disabling End-Of-Wash
Buzzer
To disable the buzzer sound, press
“Easy Iron ( ) and Prewash ( )”
touchpads at the same time for 3
seconds, and listen for “BEEP, BEEP”.
To return to default configuration press
these 2 touchpads at the same time for
3 seconds, and listen for “BEEP”.
3.7
Start/Pause ( ) and
Add Clothes ( ) Touchpad
This touchpad has 2 functions:
●
Start/Pause ( ):
To interrupt a program which is
running, press this touchpad to pause
the machine, the Start/Pause pilot light
flashes.
After you have selected the desired
program and options, press this
touchpad to start the machine. The
Start/Pause pilot light will stop flashing
and remain lit until the water level is
above the bottom edge of the door then
pilot light goes OFF. If you have
selected a “Delay End” option, the
countdown will begin and will be shown
in the display.
To restart the program from the point at
which it was interrupted, press this
touchpad again, the Start/Pause pilot
light will stop flashing.
●
Add Clothes ( ):
While running a program, you may
add clothes by:
Pressing the “Start/Pause”
touchpad to pause the program.
You can only add clothes if
“Start/Pause” pilot light is lit.
-
Wait for the machine to come to a
complete stop before opening the
door.
-
Resume the program by pressing
“Start/Pause” touchpad again.
-
Add clothing and close the door.
-
Ensure that the electrical and water
connections comply with the installation
instructions.
Put 2 litres of water in the detergent
compartment for washing phase. This
activates the drain system.
1.
2.
3.
Select a Cottons cycle at 90 °C,
without any laundry in the machine,
to remove any manufacturing residue
from the drum and tub then start the
machine.
During installation or before first use you
may observe some water in the machine.
This is a residual water left in the
machine after a full functional test in the
factory to ensure the machine is
delivered to customers in perfect working
order and is no cause for concern.
