Electrolux EWF1284EDW, Руководство по обслуживанию

Страница: 13 / 97

Technical Support - MDM
13/97
599 76 11-68 Rev. 01

Sensor no. 3 : SPIN SPEED (configurable)
The spin speed is always associated with the second sensor, in
combination with the six LEDs located in the bottom left hand corner
of the display.
The initial spin speed displayed is that set for the chosen programme.
Touching the sensor you can reduce the spin speed, indicated by the LED near the silk-screen printed value
on the control panel coming on. Once the lowest speed has been reached you can, if you wish, select
“No spin”,
“Stop water in tub” lighting up the relative symbol , or “Night cycle” (if compatible with the selected
programme).
The next selection will be the highest speed available for the selected programme.
The speeds that can be combined with the six LEDs are shown in the following table.
Max spin speed
(rpm)
800 1,000 1,000 1,200 1,200÷1,400 1,200÷1,400
Intermediate 600 800 800 800 1,000 1,000
Intermediate
400 400 600 400 800 800
Intermediate
No
speed
No
speed
400
No
speed
400 400
Intermediate
Rinse
hold
Rinse
hold
No
speed
Rinse
hold
Rinse
hold
No
speed
Last selection
Night
Cycle
Night
Cycle
Rinse
hold
Night
Cycle
Night
Cycle
Rinse
hold

Sensor no. 4-5-6-7 (configurable)
Each of the sensors located on the right hand side of the display can be
combined with a LED and are used to choose one of the following four
selected options:

Delayed Start

Extra-rinse

Easy Iron

Pre-wash
Depending on the option/choices, the programme duration time is
updated (via the three digits).

Sensor no. 8-9
These two sensors are positioned under the display and act as:

Time manager
Allowing the end user to lengthen or shorten the washing cycle duration,
this adjustment should be done after setting the temperature value and
the spin speed.

Sensor no. 10
This sensor has the START/PAUSE function, used to start up a washing
programme, after selecting the washing cycle and required options; it can
also pause a cycle that has already started: to allow you to change
selected option or open the door (if the temperature conditions or water
level allow for this).
The cycle re-starts if you touch the sensor again.
The Led combined with this sensor flashes slowly: in the selection phase,
during the pause and at the end of a cycle with water in the tub. It stays lit
when a cycle is running and turns off when the cycle has ended and the
door is unlocked.
While other sensors when touched immediately change from selected to de-selected, in the case of this sensor,
more time is needed to avoid unwanted cycle start ups or pauses.