Electrolux EWF 1287 EMW, Руководство пользователя

Страница: 25 / 56

Problem Possible solution
The spin phase does
not operate or the
washing cycle lasts lon‐
ger than usually.
• Set the spin option.
• Set the drain option if you set an option which ends with
water in the drum.
• Make sure that the drain filter is not clogged. Clean the
filter, if necessary. Refer to 'Care and cleaning'.
• Adjust manually the items in the tub and start the spin
phase again. This problem may be caused by balance
problems.
There is water on the
floor.
• Make sure that the couplings of the water hoses are
tight and there is not water leakages.
• Make sure that the water inlet hose and the drain hose
have no damages.
• Make sure you use the correct detergent and the correct
quantity of it.
You cannot open the
appliance door.
• Make sure that the washing programme is finished.
• Set the drain or the spin option if there is water in the
drum.
• Do the emergency drain procedure. See "Frost precau‐
tions" (in "Care and Cleaning" chapter).
The appliance makes
an unusual noise.
• Make sure the levelling of the appliance is correct. Refer
to 'Installation instruction'.
• Make sure that the packaging and/or the transit bolts
are removed. Refer to 'Installation instruction'.
• Add more laundry in the drum. The load may be too
small.
The cycle is shorter
than the time displayed.
• The appliance calculates a new time according to the
laundry load. See the ‘Consumption Values’ chapter.
The cycle is longer than
the time displayed.
• An unbalanced laundry load increases the duration time.
This is a normal behaviour of the appliance.
The washing results are
not satisfactory.
• Increase the detergent quantity or use a different deter‐
gent.
• Use special products to remove the stubborn stains be‐
fore you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
You cannot set an op‐
tion.
• Make sure that you press only the wanted touch but‐
ton(s).
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
ENGLISH 25