Range installations steps
INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL
G
Carefully slide range into cabinet opening while inserting
rear leveling leg into and FULLY ENGAGING THE ANTI-TIP
BRACKET (See Fig. 26). Make sure that the flexible
appliance conduit (Fig. 18) and the power cord (Fig. 20)
folds into the remaining open floor area behind the range
warmer or storage drawer. Make sure that the flexible
appliance conduit does not become pinched or kinked!
Pre-shape the flexible appliance conduit and power cord if
necessary to insure that the range slides into cabinet
opening properly. Be sure to check level of the range by
placing a level horizontally on an oven rack (See Fig. 27).
Surface burner heads, cap & grates.
H
It is very important to make sure that all of the surface
burner heads, surface burner caps and surface burner
grates are installed correctly.
Your appliance was shipped with the burner heads and
burner caps assembled in the correct locations (Fig. 38).
Should you need to re-install the burner caps please refer
to the Use & Care guide for more information.
REMEMBER — DO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS OR ANY OTHER MATERIAL TO
ENTER THE
GAS ORIFICE HOLDER OPENING. Always keep the Burner
Caps and Burner Heads in place whenever the surface
burners are in use.
Check electric ignition of surface burners.
Operation of electric igniters should be checked after range
and supply line connectors have been carefully checked for
leaks and range has been connected to electric power.
1.
To check for proper lighting, push in and turn surface
burner knob counterclockwise to the
(lite) position.
You will hear the igniter sparking ( Fig. 39).
2.
The surface burner should light when gas is available
to the top burner. Purge air from supply lines by
leaving knob in the
(lite) position until burner ignites.
Each burner should light within four (4) seconds in
normal operation after air has been purged from supply
lines.
3.
Visually check that the burner has lit. Once the burner
lites, turn the control knob out of the
(lite) position.
4.
The range has separate electrodes (igniters) for each
burner. Try each knob separately until all burner valves
have been checked.
I
11
Carefully slide range into cabinet
opening.
Fig. 38
1.
2 Standard burners - 9,500 BTU.
2.
Min-2-Max™ - double burner - 18,000 BTU.
3. Large burner - 14,000 BTU.
4.
Perfect Simmer burner™- 5,000 BTU
Fig. 39
1
2
3
4
1
If burner goes out, reset control to OFF.
Remove the burner control knob.
Use a thin-bladed screwdriver and adjust the inner burner
flame size with the right-hand set screw (See Fig. 40).
Adjust the outer burner flame size with the lower set screw
(See Fig. 40). Turn counterclockwise to increase flame size.
Turn clockwise to decrease flame size.
Test to verify if “LO or LOW” setting should be adjusted
(right front position ONLY)
1.
Push in and turn knob to (lite) until burner ignites.
2.
Push in and quickly turn knob to LOWEST POSITION.
3. If burner goes out, reset control to OFF.
4.
Remove the burner control knob.
5.
Use a thin-bladed screwdriver and adjust the inner
burner flame size with the right-hand set screw (See Fig.
J
Adjust the "LO" setting of surface
burner valve (for linear flow valves
only).
40). Adjust the outer burner flame size with the lower
set screw (See Fig. 40). Turn counterclockwise to
increase flame size. Turn clockwise to decrease
flame size.
