46
GB
Maintenance
Defrosting
It is a normal phenomenon that a part of the internal
humidity is turned into frost and ice during operation.
However, a thick frost or ice layer has an insulating
effect and thus reduces the freezing performance lead-
ing to rising internal temperatures and higher energy
consumption and, above a certain layer thickness, to
difficulties in the opening or sudden break of the freez-
er door.
If the formation of frost and ice is not significant, use the
spatula (accessory) to remove or scrape off the frost or
ice layer.
Please note that the tray shown in the figure is not an
accessory.
If the frost or ice layer is too thick for removal with the
spatula, defrosting will be necessary. The frequency of
defrosting depends on the actual use.
To defrost the product:
Set the thermostat to position <<
>>.
Disconnect the product from the mains.
After removing them from the freezer, place the frozen
foods in a basket padded with paper or cloth and kept
in a cool place, or relocate them into the deep-freezing
or cooling compartment of a normal fridge.
Leave the door open.
From time to time use a cloth or sponge to sweep off
laterally the defrost water so that it can be collected in
a drain at the bottom of the product and then remove
the water as follows:
Place a tray of sufficient height in front of the product.
Following the arrow, carefully pull out the defrost water
drain, located in the central bottom section of the prod-
uct, to let the defrost water flow into the tray.
The defrosting process will be quicker if you put a pan
filled with hot water on the cooling plates used as
shelves.
Once defrosting is completed, dry the wet surfaces and
push back the defrost water drain.
Connect the product to the mains.
Rotate the thermostat to position <<-18°C>> and let the
product operate in quick freeze mode for at least 2
hours before putting back the formerly removed frozen
foods.
Regular cleaning
It is practical to clean the inside of the freezer and
defrost it at a time.
Household cleaner or soap must not be used.
After breaking the circuit wash the appliance using luke-
warm water and wipe it.
Clean the door gasket with clean water.
After cleaning apply voltage to the appliance.
It is recommended to remove the dust and dirt collect-
ed on the back of the appliance and the condenser
once or twice a year.