1
2
Location
The appliance should be installed well away
from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can
circulate freely around the back of the cabi-
net. To ensure best performance, if the ap-
pliance is positioned below an overhanging
wall unit, the minimum distance between the
top of the cabinet and the wall unit must be
at least 100 mm . Ideally, however, the ap-
pliance should not be positioned below over-
hanging wall units. Accurate levelling is en-
sured by one or more adjustable feet at the
base of the cabinet.
If the cabinet is placed in a corner and the
side with the hinges facing the wall, the dis-
tance between the wall and the cabinet must
be at least 10 mm to allow the door to open
enough so that the shelves can be removed.
Warning!
It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore
be easily accessible after installation.
15mm
15mm
100mm
Door reversibility
Important!
To carry out the following
operations, we suggest that this be made
with another person that will keep a firm hold
on the doors of the appliance during the
operations.
To change the opening direction of the door,
do these steps:
1. Remove the plug from the power socket.
2. Tilt back the appliance carefully so that
the compressor cannot touch the floor.
3. Unscrew both adjustable feet.
4. Unscrew the screws of the door bottom
hinge.
5. Take off the appliance door by pulling it
slightly downwards.
6. Unscrew the top door hinge pin of the
appliance then screw it back on the oth-
er side.
22
electrolux
