Electrolux ETG7256GKR, Руководство пользователя, Страница: 9 / 36

1.Test the appliance
press the control knob and turn to full flame setting to activate the electric igniter. The burner will
ignite. Adjust control knob to the desired setting. On initial usage you may have to repeat this
ignition function several times (to allow air to be purged from the gas supply system). No
adjustment should be necessary. If any problem occur, refer to the servicing instructions or the fault
finding chart.
Max Flame
Power off
Min Flame
Please notice ETG7296GKR and ETG7286GKR have flame failure devices, pushed down as far as
possible for approximately 5 seconds. If the flame goes out when the knob is released simply depress
the knob again, this time holding it down with slightly more force for the same length of time.
Test and operate
2.Adjust air door
Normal and good performance flame should be blue and very small yellow flame at the flame
tip. if you find the flame is too much yellow, you can adjust the valve air door to get the desired
flame.
WARNING
Air door has been set at the factory, it is not recommended the u s er to adjust by themselves.
Ask qualified technician or installer to adjust if necessary. When adjust the air door, make
sure the gas pipe is well connected.
Using the hob correctly
To ensure maximum burner efficiency, it is strongly recommended that you use only pots and
pans with a bottom fitting the size of the burner used, so that the flame will not spread beyond
the bottom of the vessel . Recommed pot size is from 120mm to 280mm.
Normal flame
flame too short
airdoor open too much
flame too long
airdoor open not enough
Air door
Air door Air door Air door