Electrolux ESL79200RO, Руководство пользователя

Страница: 25 / 32

13. INSTALLATION
If floor is not level, adjust
levelling legs to suit
The hose should not be
extended by more than
2 metres or water pump-
out problems may occur
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Gap on both sides should be
equal, & no greater than
5 mm per side.
Secure dishwasher with
brackets or screws provided
Min. 400 mm straight
section
600mm max
300mm min
400mm
min
DISHWASHER
SINK
POWER OUTLET
Install the appliance under a kitchen
counter.
Put the appliance adjacent to a water tap
and a water drain.
For the venting of the appliance only
water hoses and mains cable openings
are necessary.
13.1 Adjusting the height of the
appliance
1. To adjust the front height, turn the 2
front feet counterclockwise to raise
the appliance.
2. To adjust the rear height, turn the
middle screw counterclockwise to
raise the appliance.
13.2 Adjusting the level of the
appliance
Correct levelling of the appliance allows
the door to close and seal properly.
If the door does not close correctly, raise
or lower the adjustable feet to level the
appliance.
13.3 Water inlet hose
Connect the inlet hose to a water tap
with an external BSP thread spout of
3/4''.
For best washing performance, it is
recommended to connect the appliance
to a cold water supply.
Energy savings can be made by
connecting the appliance to a Solar
water system and using economy
options, however the water temperature
must not exceed 60° C.
ENGLISH 25