Electrolux ESL6123, Инструкция

Страница: 9 / 16

In this fully integrated appliance the controls are located on the
top of the door. When selecting a programme, the door needs
to be open.
1. Check the filters
Ensure they are clean and properly positioned (see
"Maintenance and cleaning").
2. Press the On/Off push button
The On/Off indicator light comes on.
3. Check that there is rinse aid and salt
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans,
plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely
6. Measure out detergent
Add the required amount of detergent into the dispenser.
Close the detergent dispenser lid.
7. Set the programme
Press the programme push button which corresponds to
the washing programme you wish to select, the
corresponding indicator light starts flashing.
8. Start the programme
Close the door, the programme will start automatically.
An audible signal advises you that the programme has
started and the indicator light which corresponds to the
programme underway is now permanently on.
9. To cancel a programme in progress
If the door has not been closed and therefore the
programme has not started, it is possible to change the
selection made simply pressing the push button of
another programme.
A programme underway can be cancelled, by opening
the door and pressing for about 1 second the programme
push button of the programme underway.
The corresponding indicator light will turn off.
A new programme can now be selected.
10. At the end of the washing
programme
The dishwasher will automatically stop and an
intermittent audible signal will be heard when the
programme has ended.
The indicator light of the programme just ended turns off
while the "end of cycle" indicator light flashes.
The On/Off indicator light remains illuminated until the
On/Off push button is depressed.
Open the door and switch off the dishwasher by pressing
the On/Off push button.
Wait a few minutes before removing the dishes; in this
way they will be cooler and drying will be improved.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Important!
In general it is not advisable to open the door while the
machine is working; if the door is opened however, a
safety device ensures that the machine stops.
Care must be taken if the door is opened during the hot
phase or immediately after a programme has finished, as
steam may escape.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
9
Operating sequence