4
www.electrolux.com
CNT
CNS
KR
ID
TH
VN
EN
3.
Plug power cable into a power outlet.
The power indicator light turns on, red colour. Set the
temperature by turning the temperature selector to adequate choice. When the light turns green, the
iron is ready to use. The light will switch between red and green as the iron is maintaining the selected
temperature. The SafeTouch indicator turns red when the iron reaches 40°C.
4.
Using the spray mist and steam boost function.
Ensure that the water tank is at least 1/4 full. Use spray
mist to pre-dampen fabrics by pressing the spray button several times to release a fine mist (A). To use
the steam boost function, ensure that the water tank is at least 1/2 full. Press the steam boost button
several times to prime pump (B).
5.
Steaming hanging items.
Vertical steam boost function is ideal for steaming curtains, suits and delicate
fabrics. Hang the item on a hanger, hold the iron at a distance of 10–20 cm and press the steam boost
button.
6.
3-way Auto-OFF.
If iron is left unattended on soleplate or on the side, it turns off after 30 seconds. If
left unattended on the heel, it turns off after 8 minutes. To turn on, just begin to iron again. Then the
indicator light will flash yellow and the sound alert will beep 6 times before Auto-OFF.
CLEANING AND CARE
7.
Always store iron on its heel rest.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do
not use any chemical solvents, as these will damage the surface. Do not store the iron with water in the
tank. Wind the mains cord around the cable wrap facility.
8.
Auto-clean function.
Fill the iron with water and heat up the iron. When the indicator light turns green,
unplug the iron. Hold the iron over a sink, press and hold the cleaning button. Use a full tank of water.
Release button to stop Auto-clean function. Repeat the procedure if necessary. NOTE! Do not use any
descaling fluid or vinegar.
9.
Cleaning the soleplate.
Do not use scouring pads or harsh cleaners on the soleplate as these will
damage the surface. To remove burnt residue, iron over a damp cloth while iron is still hot. To clean the
soleplate, simply wipe with soft damp cloth and wipe dry.
IRONING CHART
Fabric
Temperature setting
Ironing recommendation
Acrylic
•
Dry iron on reverse side.
Acetate
•
Dry iron on reverse side while still damp or use spray to
dampen.
Nylon & Polyester
•
Iron on reverse side while still damp or use spray to dampen.
Rayon
•
Iron on reverse side of fabric.
Viscose
•
Silk
••
Iron on reverse. Use an ironing cloth to prevent shine marks.
Cotton blends
••
Check label and follow manufacturer’s instructions. Use
setting for the fibber requiring lowest setting.
Wool & wool blends
••
Steam iron on reverse side or use ironing cloth.
Cotton
••
Corduroy
•••
Steam iron on reverse side or use ironing cloth.
Linen
•••
to “max”
Steam iron on reverse side or use ironing cloth to prevent
shine marks, especially with dark colours.
Denim
•••
to “max”
Use steam boost if needed.
Varied ironing speed and fabric dampness might cause optimal setting to differ from that recommended in the
table.
Tips:
Always start ironing the fabrics that require low ironing temperature setting, and then increase the
temperature setting for fabrics which require higher temperature. The iron heats up faster than it cools down.
