9
ENGLISH
9
LED DISPLAY Button:
Press this
button to clear the display on the
indoor unit, press it again to light the
display.
10
RESET Button:
Once the recessed
RESET button is pressed, all of the
current settings will be cancelled and
the controller will return to the initial
settings.
11
FOLLOW ME Button(on some
models):
Push this button to initiate
the Follow Me feature, the remote
display is actual temperature at its
location. The remote control will
send this signal to the air conditioner
every 3 minutes interval until press
the Follow Me button again. The air
conditioner will beep to indicate the
Follow Me feature has ended if it
does not receive the signal during
any 7 minute interval.
12
SELF CLEAN(AUTO CLEAN)
Button:
Press this button under
COOL or DRY mode, the self clean
function is activated. Under SELF
CLEAN mode, the air conditioner
will automatically clean and dry the
Evaporator and keep it as fresh for
the next operation.
13
CLEAN AIR Button(on some
models):
When push this
button, the Ionizer/Plasma Dust
Collector(depending on models) is
energized and will help to remove
pollen and impurities from the air.
14
DIRECTION/SWING Button:
Used
to stop or start horizontal louver
movement or set the desired up/
down air flow direction. The louver
changes 6 degree in angle for each
press. If keep pushing more than 2
seconds, the louver will swing up and
down automatically.
15
MODE Button:
Each time the button
is pressed, the operation mode is
selected in the sequence of the
following:
AUTO
COOL
DRY
HEAT
FAN
NOTE:
Please do not select HEAT mode
if the machine you purchased is cooling
only type. Heat mode is not supported by
the cooling only appliance.
16
TEMP Button :
Push this button
to increase the indoor temperature
setting in 1°C increments to 17°C.
Note:
•
Buttons design might be slightly
different from the actual one you
purchased depending on individual
models.
•
All the functions described are
accomplished by the indoor unit. If the
indoor unit has no this feature, there is
no corresponding operation happened
when press the relative button on the
remote controller.
