Electrolux EME1925, Руководство пользователя

Страница: 8 / 24

EME1925
U
English
8
N.B. When you unpack the oven, check that the
product is free from damage. Damage or any missing
parts must be reported immediately to the retailer. The oven, parts of the oven or the accessories may
be wrapped by a protection foil. If so, you must
remove this foil before using the oven. Do not leave
packing material so that small children can play with
it. This can be hazardous.
1. Remove any promotion label from the door.
2. The oven should be installed on a flat, level
surface. The surface must be strong enough to
safely bear the weight (13.5 kg) of the oven, and
the contents. To avoid the possibility of causing
vibration or noise the oven must be in a stable
position.
3. Keep the oven away from heat and water.
Exposure to heat and water can lower oven
efficiency and lead to malfunctioning, so be sure
to install the oven away from heat and water
sources.
4. Do not block air vents on the top and the sides of
the cabinet and also do not place any articles on
the top of the oven. If air vents are blocked during
operation, the oven may overheat, and this may
lead to malfunctioning. Hot air escapes from the
vents, so be sure not to obstruct it or let curtains
come between the oven and the rear wall.
5. Place the oven as far away from radios and TV’s
as possible. This oven does conform to EEC
requirements of radio interference suppression,
but some interference may occur if it is placed too
close to a radio or TV, so keep them as far apart
as possible.
6. If positioned in a corner, leave a gap of at least
15 cm from the walls and 17 cm above the
microwave.
IMPORTANT! The oven can be placed almost
anywhere in the kitchen. Make sure the oven is
placed on a flat, level surface and that vents as
well as the surface underneath the oven are not
blocked (for sufficient ventilation).
Connecting to the mains
The oven is delivered with the power cord and a plug
for 230V, 50Hz, earthed socket outlet.
Earth protection minimises the risks should a short
circuit occur. Check to ensure the voltage of the oven
matches the supply.
N.B. If the oven is connected to the socket via an
extension cord, make sure the cord is earthed.

WARNING
: This appliance must not
be used on a non-earth protected power
supply. Contact an electrician if you are
uncertain regarding electrical connection
of the oven or provision of earth protection
of the supply.

WARNING
: This appliance must be
earthed. If this appliance is fitted with a
non-rewireable plug for which your socket
is unsuitable, the plug should be cut off
and the appropriate plug fitted. If it is
necessary to change the fuse in a non-
rewireable plug, the fuse cover must be
refitted. If the fuse cover is lost or
damaged, the plug must not be used until
a replacement is obtained.

WARNING
: It is hazardous for
anyone other than factory trained service
personnel to carry out any service or
repair operation that involves the removal
of a cover that gives protection against
exposure to microwave energy.

WARNING
: If the supply cord is
damaged, it must be replaced by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a
hazard.
Unpacking
Installation.