EN Publication
number
Nr
Rev. xx
Month/year
PR - 30/37
30
4 PCB Power Module used for level 2-3 (position 014A)
4.1 Introduction
Power module is intended as a module PCB for mainly vacuum cleaners from Electrolux Floor Care
& Small Appliances AB. The module is intended to consist of a Triac, triggering a motor, and a power supply
for additional connected electronic.
The component layout for the power module should look like below sketch:
1. Power Module PCB.
2. Connector main voltage
3. Alternative main power connector / main power out
4. Motor connector
5. Connector to control PCB
All different kinds of Power modules have the same configuration of connector configuration, simplifying
design, service and cross over.
4.2 Connection for control unit
To be able to control the power module a control unit is connected to the 5-pol connector, which also
power supplies the control unit with 5VDC.
The configuration for the connector is following:
1.
Ground.
2. 5VDC, maximum current according to level of power module.
3. Zero cross signal, square wave that follows the main frequency (5V amplitude).
4. Reserved for TCO signal (temperature control signal). Not implemented on the PCB, only
reserved for the function.
5. Triac ignition signal from the control unit to the power module.
4.3 High Current Power Module
The high current power module consists of a switched power supply for providing the logical voltage
with higher current output.
Содержание EL4300
Страница 3: ...EN Publication number Nr Rev xx Month year PR 3 37 3 1 General description ...
Страница 5: ...EN Publication number Nr Rev xx Month year PR 5 37 5 1 1 Exploded view ...
Страница 14: ...EN Publication number Nr Rev xx Month year PR 14 37 14 Take out the two screws and remove the handle Handle ...
