Electrolux EKE6100, Инструкция

Страница: 5 / 28

The safety equipment
5
The safety equipment
There should be at least 40 cm of worktops on both sides
of the cooker
(
SEE PICTURE
)
. Alternatively the cooker can be
installed with a wall or a tall kitchen unit on one side and
a worktop on the other.
Child safety is further improved if the following
equipment is fitted/in use:
Non-tip device
The non-tip device should be fitted, to prevent the
cooker from tipping if subjected to an abnormal
loading. The non-tip device can only provide pro-
tection when the cooker is pushed into its normal
position.
Before fitting the non-tip device, make sure the cooker has
been levelled and adjusted to the correct plinth height (see
“Installation” on p. 20).
1
Draw a line on the wall – after levelling the
cooker – along the top edge of the hob (see illus-
tration).
2
The measurements shown can be applied
whether the non-tip device is fitted to the right
side (see illustration). Measure and mark where
the non-tip device is to be placed, then screw it
onto a solid material or a suitable reinforcement
or fixings.
NOTE
! If the space between kitchen units is wider than
the cooker, you will need to alter the measurements
shown in the illustration if the cooker is to be centred.
3
If you alter the measurements, remember to
align the cooker correctly when pushing it into
place, so that the non-tip device enters the hole
on the cooker rear.
The hob guard
The hob guard should be fitted to make it harder
for children to reach pans on the hob.
1
Press the plugs into the front holes.
2
Place the guard on the cooker with the plugs over the
edge of the hob.
3
Angle the guard downwards and then back upwards
so the edges on its two sides engage under the edge
of the hob.
4
Lock it in place with the rear plugs.
min. 40 cm min. 40 cm
35-65 mm
55-60 mm
2
3
1
4
5