Electrolux EHD60150P, Руководство пользователя

Страница: 11 / 16

Problem Possible cause and remedy
A Sound operates and the ap-
pliance deactivates.
A sound operates when the ap-
pliance is deactivated. You put something on one or more sensor fields. Remove the ob-
ject from the sensor fields.
The appliance deactivates.
You put something on the . Remove the object from the sen-
sor field.
The residual heat indicator
does not come on. The cooking zone is not hot because it operated only for a short
time. If the cooking zone should be hot, speak to the service cen-
tre.
The Automatic Heat Up func-
tion does not operate. • There is still residual heat on the cooking zone. Let the cooking
zone become sufficiently cool.
• The highest heat setting is set. The highest heat setting has the
same power as the Automatic Heat Up function.
The heat setting changes be-
tween two levels. The Power management is activated. See the section Power
management.
The sensor fields become hot. The cookware is too large or you out it too near to the controls.
Put large cookware on the rear cooking zones if it is necessary.
There is no signal when you
touch the panel sensor fields. The signals are deactivated. Activate the signals (see OffSound
Control).
comes on
The Automatic Switch Off operates. Deactivate the appliance and
activate it again.
comes on
• No cookware on the cooking zone. Put cookware on the cook-
ing zone.
• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too small for the
cooking zone. Move cookware to a smaller cooking zone.
and number comes on.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some
time. Disconnect the fuse from the electrical system of the house.
Connect again. If
comes on again, speak to the service cen-
tre.
comes on
There is an error in the appliance, because a cookware boils dry.
The protection against become too hot for the cooking zone op-
erates. The Automatic Switch Off operates.
Deactivate the appliance. Remove the hot cookware. After, ap-
proximately 30 seconds activate the cooking zone again.
should go out of the display, residual heat indicator can stay. Let
the cookware become sufficiently cool and check it with the sec-
tion Cookware for the induction cooking zone.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter, code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on. Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer service
and conditions of guarantee are in the guar-
antee booklet.
electrolux 11