Electrolux EFT 800, Руководство пользователя, Страница: 4 / 9

4
Using the cooker hood
The control panel
Best results are obtained by using low speed for normal
conditions and high speed when smells and steam are more
concentrated.
The control panel has two switches (Fig. 5): one controls the
worktop illumination, the other controls the power to the
motor and the three fan speeds.
For the best performance, we recommend using the highest
speed in particular cases of strong odour and vapour
concentration.
Turn the hood on a few minutes before you start cooking
then you will get an underpressure in the kitchen. It should
be left on after cooking for about 15 minutes or until all
steam and smells have disappeared.
Correct ventilation
If the cooker hood should be working correctly there must
be an underpressure in the kitchen. It is important to keep
the kitchen windows closed and have a window in an
adjacent room open.
Important to know
Not applicable for recirculation. Great care must be taken if
the hood is used at the same time as a burner or fireplace
(e.g. gas, diesel, coal or wood heaters, water heaters, etc.), as
the hood will expel air which is required by these other
appliances. Attend to it by opening a window. The negative
pressure in the room must not exceed 0,04 mbar to prevent
fumes being drawn back into the room by the cooker hood.
Fig. 5
Maintenance and cleaning
Cleaning the hood
Clean the outside of the hood using a damp cloth and a
mild detergent. Never use corrosive, abrasive or flammable
cleaning products.
Cleaning the grease filters
Clean the filter every month or every other month according
to how much the hood is used. The cleaner the filters, the
better it collects grease. Remove the filter by (Fig. 6):
Remove the filter:
•
Open the latch L and rotate the suction grid downwards.
• To remove, pull forward from the right hand side and
unhook.
• Release the clips M.
Leave to dry before refitting it, be sure that the grease filter
cover the whole aspirating surface before refitting.
Suction grid must be cleaned as well as the grease filter.
Clean the filter regularly. The grease that
collects in the filter and the duct could ignite
if a hot plate is left on (or if overheating
occurs). Before doing any maintenance work on the hood,
disconnect it from the main supply by
disconnecting the plug from the wall socket or
unscrewing the fuse.
Fig. 6
1 2 3
O O I
L
M