Electrolux EFP 4200, Руководство пользователя

Страница: 43 / 192

g
45
depending on the purpose of
application (see "Inserting cutting
insert in insert holder").
0
Place desired tool on spindle.
– Whisking disk, metal blade and
plastic blade (fig. 8) mesh with
the teeth underneath on the
spindle.
– The insert holder (fig. 11) rests
on the hexagonal spindle.
3 Preferably hold the insert holder
with two fingers in the two handle
holes.
Fitting the cover (fig. 6)
– The red warning lamp (fig 4/a)
flashes.
0
Place cover (fig. 1/F) on the all-pur-
pose bowl (mark
on mark )
and turn counter-clockwise to the
stop. The cover can be heard to
engage. The nose of the cover is
then directly above the handle
(mark
on mark ).
– The red warning lamp (fig. 4/a)
extinguishes.
0
Insert stopper (fig. 1/E) in filling
inlet.
Inserting cutting insert in
insert holder (fig. 10)
The appropriate insert must be
placed in the insert holder depend-
ing on use.
3 The inserts are contained in the
hinged accessories compartment
(fig. 1/K) in the motor casing.
1 The inserts are very sharp. They
should be held only with the
handle!
0
Open accessories compartment by
pulling the handle (fig. 9).
0
Take required insert by the handle
from the accessories compartment
(fig. 9).
0
Place the insert with the tip at the
centre of the insert holder and
place in the recess of the disk
(fig. 10).
0
To remove the insert draw slightly
outwards with the handle and
raise.
Operating multifunction
section
(depending on model)
0
Open cover (fig. 1/F) and place all
ingredients required in the all-pur-
pose bowl.
Caution: Do not exceed maxi-
mum filling volume:
– liquid 1.75 litres
– solid 1.5 litres
3 Further ingredients can be added
during operation through the filling
inlet. The filling beaker in the stop-
per (fig. 1/E) can also be used for
this purpose. Close the filling inlet
immediately each time to avoid
splashes.
1 Use the stopper exclusively to
compress the cutting items!
0
Start the appliance: turn speed
selector (fig. 1/l) right to the
desired speed setting or press the
pulse button (fig. 1/J).
3 It is recommended to start at a
slow speed and then to increase
the speed. The appliance oper-
ates at maximum speed by press-
ing the pulse button.
Refer to the section "Tips on using
multifunction section" for reference
values.
1
If the warning lamp (fig. 4/a)
flashes and the appliance cannot
be started, the safety cover for the
mixer drive (figs. 1/T and 4) is not
properly fitted.
0
Switch off appliance: turn speed
selector left to the "0" position.
www.preciz.hu