Electrolux EFLS210TIS, Инструкция по использованию и уходу

Страница: 8 / 22

Operating Instructions
STEPS
TIPS IMPORTANT
4. Press the
power
button and
select the
appropriate
cycle and
settings for
each load.
Add cycle
options as
desired.
• See Cycle Selection, Cycle Settings, and Cycle
Options for detailed descriptions of cycle controls.
• See Settings Chart to determine which settings are
available for each cycle.
• To provide the best care, not every setting or op-
tion is available with every cycle. If attempting to
select an unavailable setting or option for any given
cycle, a beep will be heard and the corresponding
setting/option LED will not light. See Settings Chart
for information of available options for each cycle
by model.
DO NOT over-dry.
Over-drying can
cause wrinkles,
shrinkage, lint, and
a build up of static
electricity.
5. Close the
dryer door
and start
the drying
cycle.
• To start the drying cycle, close the door and press
the start/pause button.
• To add an item to the dryer drum, press start/
pause . The estimated remaining cycle time will be
shown in the display. The LED above the start/
pause button will blink indicating that the cycle has
been paused. Opening the door with a cycle run-
ning will also pause the cycle. Add the item, close
the door and press start/pause again to resume
the cycle.
• To change the cycle and/or settings once the cycle has
begun (after the start button has been pressed), either
rotate the knob to the reset position (12 o’clock posi-
tion) OR press the power button to turn off the unit
and cancel the cycle. Press the power button again to
turn on the unit. Select the new cycle and/or settings,
and press
start/pause
to begin. Changing a cycle se-
lection without canceling the current cycle WILL NOT
change the cycle.
NOTE
: There is an exception if the
start
button has
been pressed to begin a cycle and the delay start
function is activated and counting down. In this case,
during the delay start countdown, the cycle can be
paused and cycle settings can be changed. Then
press start/pause again to resume the delay start
countdown.
• To cancel a cycle, turn the knob to the reset
position (12 o’clock position) OR press the power
button to turn off the unit.
When drying a single
large or bulky item,
such as a comforter,
pause the cycle part
way through to turn
the item “inside out”
and maximize drying
effectiveness.
6. Remove
items when
done.
• A signal will sound at the end of the cycle if the
mute sound option is not activated.
• Immediately remove items when the cycle is
completed and hang or fold.
7. Clean the
lint filter
and empty
the water
container.
• See
Care and Cleaning section of this instruction.
• CLEAN LINT will be displayed at the end of the
cycle as a reminder to remove lint from filter.
• EMPTY WATER CONTAINER will be displayed at
the end of the cycle as a reminder to completely
drain the container. This message may also be
illuminated during the cycle if the container
becomes full.
ALWAYS CLEAN
LINT FROM FILTER
and DRAIN WATER
CONTAINER at
the end of each
cycle (see warning
on previous page).
8