Electrolux EFC60420, Руководство пользователя

Страница: 35 / 44

Installation
electrolux 35
EN
INSTALLATION
• Repeat this operation on the other
side.
• Drill ø 8 mm holes at all the centre
points marked.
• Insert the wall plugs
11
in the holes.
• Fix the lower bracket
7.2.1
using the
12a
screws (4,2 x 44,4) supplied.
• Fix the upper bracket
7.2.1
and the
air outlet connection support
7.3
to-
gether using the 2 screws
12a
(4,2 x
44,4) supplied.
• Insert the two screws 12a (4,2 x 44,4)
supplied in the hood body fixing holes,
leaving a gap of 5-6 mm between the
wall and the head of the screw.
Wall drilling and bracket fixing
Wall marking:
• Draw a vertical line on the supporting
wall up to the ceiling, or as high as
practical, at the centre of the area in
which the hood will be installed.
• Draw a horizontal line at 650 mm
above the hob.
• Place bracket
7.2.1
on the wall as
shown about 1-2 mm from the ceil-
ing or upper limit aligning the centre
(notch) with the vertical reference line.
• Mark the wall at the centres of the
holes in the bracket.
• Place bracket 7.2.1 on the wall as
shown at X mm below the first brack -
et (X = height of the upper chimney
section supplied), aligning the centre
(notch) with the vertical line.
• Mark the wall at the centres of the
holes in the bracket.
• Mark a reference point as indicated
at 116 mm from the vertical reference
line and 320 mm above the horizontal
reference line.
���
��
���
���
�
���
���
���
��������
�����