Electrolux EFC 928, Руководство пользователя

Страница: 4 / 12

4
= Lighting, on/off.
= Fan off
= Fast speed switch (P+ the led on the bottom
right side of the display flashes). This speed
should be used when the concentration of
cooking fumes or odours is particularly strong
(for example when frying, cooking fish etc.).
The fast speed will run for about 5 minutes
and then return to the speed previously set
automatically (1, 2 or 3), or switch off if no
speed was selected.
To turn off the fast speed, before the end of
the 5 minutes, press button and .
= Display showing fan speed (1-3-P), change
grease filters (grease filter saturation indicator
- F) and change activated carbon filters
(carbon filter saturation indicator - C).
A lighted Led on the right bottom side
indicates the hood is in stand-by
Warning!
The active carbon filter saturation function is
not activated.
In order to activate the carbon filter saturation
indicator, press buttons and
simultaneously for 3 seconds. Initially, only
letter F will fbe displayed, then after the 3
seconds have passed, letter C will be
displayed as well, indicating that the carbon
filter saturation control system is active.
To switch off the system, re-press the same
two buttons: letter C appear on display and
after 3 seconds letter it disappear and the
device will be switched off.
Using the cooker hood
The control panel
Best results are obtained by using low speed for normal conditions and high speed when smells and steam are more
concentrated.
Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should
be left on after cooking for about 15 minutes or until all steam and smells have disappeared.
The control panel is located on the front right side
= Decrease fan speed button for reducing
speed of motor from 3 down to speed 1.
= Increase fan speed button for increasing
speed of motor from 1 to 3.
If the hood fails to operate correctly,
briefly disconnect it from the mains
power supply for almost 5 sec. by pulling
out the plug. Then plug it in again and
try once more before contacting the
Technical Assistance Service.
Always press the fan off button before disconnecting
the hood from the mains supply.
Correct ventilation
If the cooker hood should be working correctly there
must be an underpressure in the kitchen. It is important
to keep the kitchen windows closed and have a window
in an adjacent room open.
Important to know
Not applicable for recirculation. Great care must be
taken if the hood is used at the same time as a burner or
fireplace (e.g. gas, diesel, coal or wood heaters, water
heaters, etc.), as the hood will expel air which is
required by these other appliances. Attend to it by
opening a window. The negative pressure in the room
must not exceed 0,04 mbar to prevent fumes being
drawn back into the room by the cooker hood.