Electrolux EDW 1100, Руководство по обслуживанию

Страница: 29 / 56

- 29 -
.
General information
- Calling the service functions is similar with all designs or key arrangements.
- Always use the keys SO. S1. S2 and S3 independently from their program assignment depending on
the model.
- In service function mode, you can ALWAYS call „Selection of an Add. Wash Cycle“ with key combination
S1 and S2.
Use key S1 to modify the settings.
- From the works settings, no additional wash cycle is set.
- If this function is activated, an additional wash cycle is ALWAYS added, except for „prewash extra“.
This will extend program run times up to about 10 minutes. This additional wash cycle will be executed
until the function is deactivated again.
Always applicable:
In order to call the totality of service functions always first press the function keys S1 and S3 prior to
switching the appliance on by means of ON/OFF switch S0!
Keep the keys pressed for about 4 seconds in order to activate the function. This procedure is
intentionally distinguished from those for the customer functions.
Calling the function „Additional Wash Cycle“
1. Simultaneously press Sl und S3 and...
2. ... switch on the appliance with ON/OFF switch S0
Keep keys S1 und 83 pressed simultaneously until 3
acknowledging LEDs LD1. LD2 and LD3 are flashing
(Short-time illumination of LEDs is possible and does not constitute any
fault)
3. Simultaneously press Sl and S2 until the
acknowledging LED LD1 is flashing. LEDs LD2 and
LD3 will go dark.
The „End“-LED indicates whether the Additional Rinsing
Process is activated or deactivated.
„Ende“-LED an = zusätzl. Spülgang angewählt
„Ende“-LED aus = kein zusätzl. Spülgang
Switching this function on or off:
4./5. Any further activation of function key S1 will swith
the addition alternately on or off.
Abandoning the function:
After the last activation of function key S1you can
leave the special program as follows:
After 60 seconds automatically all indications will
go dark, except for the LD0 of the ON/OFF key
or
you switch the appliance off by means of ON/OFF key
S0.
Saving the status settings
Immediately after each input of data, the currently
valid status will be saved.
8.1.5. Service Function / Additional Rinsing Process
1.
blinkt
... AUS nach 60s ek. automatis ch
... AUS dur ch manuelle Betätigung über Ein/Aus
S 0
L D0
S 0
L D0
S 0
L D0
T as ten S 1/S 3 für ca. 4 S ek. halten bis LD1-L D3 blinken!
S 2
L D2
L D1
L D3
S 1
2.
S 0
L D0
L D2
L D1
L D3
blinken
S 2
S 1
3.
S 0
L D0
L D1
E NDE
S 2
S 1
blinkt
4.
S 0
L D0
L D1
E NDE
blinkt
5.
S 0
L D0
L D1
E NDE
S 1
S 1