21
Something not working?
If the tumble dryer is not working correctly please
carry out the following checks before calling an engi-
neer.
Symptom
Possible cause
Solution
The tumble dryer will not start
The appliance is not plugged in
Plug in the appliance
The fuse has blown
Check the fuse
The START/PAUSE (START/
PAUSE) button has not been
pressed
Press the START/PAUSE (START/
PAUSE) button
No program has been selected
Select the required program
The door is not properly closed
Close the door
The water reservoir is full
Empty the water reservoir
The results are unsatisfactory
The wrong program has been
selected
Select a different program
Fluff filter blocked
Clean the fluff filter
Condenser covered with fluff
Clean the condenser
The tumble dryer has been over-
loaded
Observe the maximum loads stated
for each program
Laundry not sufficiently spun prior
to tumble drying
Ensure the wash load is well spun
before tumble drying
The vent in the base of the appli-
ance is covered
Ensure the vent is clear
A residue may have formed on the
drum interior, blocking the sensors
Clean the inside of the drum with
white vinegar
The drying result is unsatisfactory;
the washing is still damp.
The conductivity of the water in your
locality differs from the standard
setting of the appliance.
Reprogram the standard setting, eg.
H0
instead of
H1
, for dryer washing
(see chapter “Programming Possi-
bilities“.
The drying process takes unusually
long
The condenser unit is covered with
fluff
Clean the condenser unit
Fluff filter is clogged
Clean the fluff filter
The door cannot be opened with the
DOOR (TÜR) button
Electric mains plug not connected
Connect the mains plug
Program selector set to OFF (AUS)
Set a program. The fill-in door can
be opened at any time by pressing
firmly against the door (pressing
location
)
The door cannot be closed
Fluff filter has not been inserted cor-
rectly and/or the filter lid not closed
Replace the fluff filter and ensure
the filter lid is closed
The drum illumination does not
work
The program selector is in the OFF
(AUS) position
Turn the program selector dial to
LIGHT (BELEUCHTUNG)
The bulb needs replacing
Replace bulb
Содержание EDC 5375
Страница 1: ...Operating Instructions ctions C o n d e n s e r D r y e r EDC 5375 g 822 944 179 01 1101 ...
Страница 28: ......