8
Filter checking device
The cooker hood is fitted with a device which indicates when the filter
must be cleaned or replaced.
Usually the device, which signals when the carbon filter needs
maintenance work, is
deactivated
.
To activate it, proceed as follows:
Switch off the cooker hood.
Press and hold the knob for approximately 5 seconds.
The
L2
LED begins to flash in green and after approximately 2
seconds the
L2
LED will also begin to flash in orange, to indicate that
the device, which indicates when it is necessary to perform carbon
filter maintenance, has been
activated
.
L2 LED - grease filter indicator
The LED lights up in green when the grease filter needs to be cleaned;
this happens approximately every 40 hours of operation.
Every time the cooker hood is used, check whether the
L2
LED is lit.
L2 LED - carbon filter indicator
The LED lights up in orange when the carbon filter needs to be
cleaned/replaced; this happens approximately every 160 hours of
operation.
Every time the cooker hood is used, check whether the
L2
LED is lit.
Resetting the filter saturation warning
After cleaning or replacing the filters, switch on the cooker hood at any
suction speed (power), then press and hold the knob for more than 3
seconds, until you hear a beep indicating that the reset procedure has
been performed successfully. The
L2
LED and the cooker hood both
switch off.
In some situations (for example, when the
L2
LED is indicating that
the grease filters and the carbon filter are saturated), the procedure
described above must be repeated.
Содержание DD 8795
Страница 1: ...DD 8795 User manual Cooker Hood ...
Страница 18: ...18 ...
Страница 19: ...19 ...
Страница 20: ...LI2VAB Ed 07 07 ...