10
1 - GENERAL INFORMATION
This hood is designed for installation over a cooking appliance fitted into a
peninsular or island kitchen cabinet. The hood can be fixed to the ceiling or to a
wooden buttress
(fig. 2)
. The hood is supplied complete with a substantial ceiling
fixing system which is fully adjustable in height to suit most installation
requirements. This canopy hood is designed to be used either in the extraction
mode (ducted to the outside) or in the recirculation mode (internal recycling).
Before commencing the installation, consideration should be given to the
difficulties to be found during installation and to the bulky weight of the
hood. The installation work must be undertaken by a qualified and
competent person in conformity to the rules concerning the evacuation of
contaminated air. The manufacturer disclaims all liability for any damage or
injury caused as a result of not following the instructions for installation
contained in the following text.
2 - COMPONENTS
The cooker hood is made up of the following components
(fig. 1)
:
2.1 - no. 1 canopy item
“C”
, including controls, worktop illumination and fan unit
2.2 - no. 1 telescopic frame consisting of:
no. 1 upper frame
“TS”
no. 1 lower frame
“TI”
2.3 - no. 1 telescopic chimney stack formed by:
no. 1 upper section item
“S”
no. 1 lower section item
“I”
no. 1 bag of screws and accessories
no. 1 recirculation venting grille item
“G”
2.4 - no. 1 recirculation spigot item
“F”
2.5 - no. 1 reduction flange Ø 150-200 item
“R”
3 - SAFETY WARNINGS
3.1 - The cooker hood ducting must not be connected to a flue which is used for
exhausting fumes from appliances supplied with energy other than electric such as
a central heating flue or water heating flue.
3.2 - Ensure that the mains voltage corresponds with the voltage on the rating plate
inside the hood.
3.3 - Connect the cooker hood to the mains via a double pole switch which has 3 mm
clearance between the contacts.
3.4 - The appliance must be earthed.
Part 1 - INSTALLATION INSTRUCTIONS
