Electrolux 36" Ceramic, Инструкция по использованию и уходу

Страница: 15 / 26

15
Setting Surface Controls
OPERATING THE TRIPLE SURFACE RADIANT ELEMENT
Both the 30” and 36” cooktops are equipped with “Triple” surface radiant
elements located as shown in Figs. 1 & 2. A touch key pad on the element
controls is used to select one of the 3 positions of the element. Indicator
lights on the control panel are used to indicate which coil of the triple radiant
element will heat. One indicator light on indicates that only the INNER coil
will heat (Fig. 3). Two indicator lights on indicate that both INNER and
MIDDLE coils will heat (Fig. 4). Three indicator lights on indicate that all 3
portions of the element will heat (Fig. 5). You may switch from either of
these settings at any time during cooking.
To Operate the Triple Surface Element:
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the
POWER
key pad until a beep sound. The power
indicator light above the
POWER
will turn ON. Note: If no other key
pad is touched within 20 seconds the request to Power ON the
cooktop will clear.
3. Touch and hold the pad for the desired triple element position
until a beep is heard. The indicator light located above the
ON OFF
Fig. 1
Fig. 2
NO NO NO NO NOTE TE TE TE TE
See the Recommended Setting for Surface Elements table, on page 12, to make the correct setting.
lock POWER warm size ON OFF ON OFF
hot surface
med
hot surface
med
timer ON OFF size
hot surface
med
ON OFF
hot surface
med
lock POWER timer warm size ON OFF ON OFF ON OFF ON OFF size ON OFF size
hot surface
med
hot surface
med
hot surface
med
hot surface
med
hot surface
med
pad will glow. Note: If no further pads are touched within 10 seconds the request to
power the element ON will clear.
4. Select the INNER (Fig. 3), MIDDLE (Fig. 4) or ALL 3 element (Fig. 5) to heat by
touching the
size
key pad.
5. Touch pad once to turn ON the power level to HI . Touch med pad once for
MEDIUM , touch pad once for power level to LO or touch
warm
pad once to set the
power level to KEEP WARM setting.
6. Each touch of the or pad will increase or decrease the power level. Lo is the
lowest power level available. Note: The power level may be adjusted at any time while
the element is ON.
7. Start most cooking operations on a higher setting and then turn to a lower setting to
finish cooking. Each surface element provides a constant amount of heat at each
setting. A glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is
too small for the surface heating area.
8. When cooking has been completed touch the
ON OFF
pad once to turn the element OFF
and if no other surface element is used touch the
POWER
key pad to turn off the cooktop.
Note: The Hot Surface Indicator Light will turn ON if the cooktop is still hot and will
remain ON until the heating surface area has cooled sufficiently.
Fig. 3
Fig. 4
Fig. 5