30
Solutions to Common Problems
OVEN CONTROL BEEPS AND DISPLAYS F1 THROUGH F10
• Electronic control has detected a fault condition. Push
CANCEL pad
to clear the
display and stop the display from beeping. Reprogram the oven. If a fault reoccurs,
record the fault number, push the
CANCEL pad
and contact an authorized servicer.
F8 IS DISPLAYED
• The door was left open and controls set for self-cleaning cycle. Close the door and
push both upper and lower oven
CANCEL pads
.
INSTALLATION
• Place oven rack in center of oven. Place a level on the oven rack. Contact installing
agent if rack and cabinet cutout flooring are not level.
• Kitchen cabinet misalignment may make oven appear to be not level. Be sure
cabinets are square and level. Contact cabinet maker to correct problem.
ENTIRE OVEN DOES NOT OPERATE
• When the oven is first plugged in, or when the power supply to the oven has been
interrupted, the display will flash. The oven cannot be programmed until the clock is
set.
• Be sure electrical cord is securely connected into the electrical junction box.
• Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact
your dealer, installing agent or authorized servicer.
• Service wiring not complete. Contact your dealer, installing agent or authorized
servicer.
• Power outage. Check house lights to be sure. Call your local electric company.
• Short in cord/plug. Replace cord/plug.
IMPOR
IMPOR
IMPOR
IMPOR
IMPORT
T
T
T
TANT
ANT
ANT
ANT
ANT
Before calling for service, review this list. It may save you both time and expense. This list
includes common experiences that are not the result of defective workmanship or material
in your cooktop.
Содержание 318 200 936 (0411)
Страница 1: ......
Страница 33: ...33 Notes ...
Страница 34: ...34 Notes ...
Страница 35: ...35 Notes ...