31
ENGL
ISH
•
Remove the tank filters "C" - "D" - "E" (Figure 24).
.
.
•
Clean the filters under a water spray using a nylon
brush.
•
Refit the door (Figure 25):
-
Lift the door as far as movement permits (horizontal).
-
Push the door inward, making sure it does not get
stuck, until the latches “S” and “T” are both lowered
in the initial position (all down). This operation is cor-
rectly done when the door cannot be pulled outward
on the side of latch “S” and that of latch “T”.
Figure 25 Refit the door
•
Close the door, gently lifting it.
•
Select the drain cycle by pressing button “M”
(Table 2 “Control panel”).
The message "CLE" ("CLEAN") will be displayed
throughout the drain cycle:
•
After a few minutes, 3 beeps indicate the end of
thecleaning cycle and “END” blinks on the display:
•
Switch off the dishwasher by pressing button “A”
(Table 2 “Control panel”).
•
Switch off at the mains.
•
Close the water supply cock.
•
Before operating the appliance again, replace the
components that have been removed.
Cleaning the nozzle jets
•
Remove the upper and lower wash arms "F" and
rinse arms "I", undoing the ring nut "H" (Figure 26).
•
Unscrew plugs “L” (Figure 26) from the rinse jets.
IMPORTANT
Descale the rinse jets “I” (Figure 28) every month
using vinegar or a descaling agent.
•
Remove jet “P” (Figure 27) by turning it clockwise
and pulling it out.
•
Unscrew plugs “R” (Figure 27) from the side jets.
•
Carefully clean the washing and rinse jets and
clean everything with hot water and neutral deter-
gent/detersive, if necessary using a soft brush or
sponge. In particular, for the jet "P" (Figure 28) use
warm water and detergent, and a soft brush "Z" if
necessary (Figure 28). Do not use sharp imple-
ments to clean the nozzle holes, which could
otherwise be damaged.
Figure 24 Tank filters
C
D
E
CLE
End
Figure 26 Rotating wash arms and rinse arms
Figure 27 Fixed wash arm removal
H
F
I
L
P
R
R
Содержание 506048
Страница 32: ...34 ...