ELECTRODRIVE Bariatric Wheelchair Mover, Руководство по эксплуатации

Страница: 13 / 28

Bariatric Wheelchair Mover—Operating Manual
13
Electronic speed control
This unit is factory programmed, and is not serviceable by the customer.
Contact Electrodrive or your local service agent for diagnosis and advice.
Fuses
The control circuit is protected against inadvertent current overloads with a 1 Amp fuse.
The charger circuit is protected by a 10 Amp fuse. These fuses are located next to the
electronic controller on the electrical panel.
Circuit breaker
The Bariatric Wheelchair Mover is fitted with a self-resetting circuit breaker in case of
momentary overload. This switch can be found next to the fuses as shown.
If the circuit breaker continues to trip multiple times in succession, test the machine, as
the motor may be damaged. Continued use could damage the unit further.
The controller is also equipped with safety shut down capabilities and will limit the
battery current as well as detect low battery voltage.
Cleaning
To clean exterior of machine wipe surfaces down with a warm damp cloth. A mild
detergent may be used for harder-to-remove grime.
Do NOT use chemical solvents, highly concentrated caustic soda
or abrasive cleaning agents. These may damage the surface quality
and may affect the integrity of polyurethane and machine lubricant
properties.
General
Any damage audible or visible to the Bariatric Wheelchair Mover should be addressed
at the time of discovery.
When not in use the unit should be stored in a cool dry place. Please ensure it is not
parked in a manner that obstructs access, causes a tripping hazard, or any other safety
related issue.
Disposal of components or material
All replaced or damaged components should be disposed or recycled properly based
on its category.