ZLX Powered Loudspeaker Series
Troubleshooting | en
29
Electro-Voice
Installation manual
2018.04 | 01 | F.01U.349.854
6
Troubleshooting
Problem
Possible Cause(s)
Action
1.
No sound
Amplifier
Verify all the electronics are on, the signal routing is
correct, the source is active; the volume is turned up,
etc.
Correct/repair/replace as necessary. If there is still no
sound, then the problem may be wiring.
Wiring
Verify you have connected the correct cables to the
amplifier. Play something at a low level through the
amplifier. Connect a test loudspeaker in parallel with the
malfunctioning line. If the sound level is gone or is very
weak, the line has a short in it (possibly a severe scrape,
pinch, or a missed connection). Using the test
loudspeaker, move down the line and test each
connection/junction until you find the problem and
correct it. Observe proper polarity.
2.
Poor Low-
Frequency
Response
With SUB menu
cross-over frequency
activated
If no subwoofers are used with the system, select the
OFF position.
3.
Intermittent output
such as cracking or
distortion
Faulty connection
Check all connections at amplifier and loudspeakers to
ensure they are all clean and tight. If the problem
persists, check the wiring. See problem 1.
4.
Constant noise
such as buzzing,
hissing or humming
Defective source or
other electronic
device
If noise is present, but no program material is playing,
evaluate each component as necessary to isolate the
problem. Most likely there is a break in the signal path.
Poor system
grounding or ground
loop
Check and correct the system grounding, as required.
Input gain knob is
not in the MIC
position
Slowly increase the input gain knob level to engage the
microphone pre-amp.
5.
No sound produced
with microphone
connected to INPUT
1 or INPUT 2
Microphone requires
phantom power.
Use a dynamic microphone that does not require
phantom power. If using a microphone requiring
phantom power, an external phantom power source is
needed.
Input gain knob is
not in the MIC
position
Slowly increase the input gain knob level to engage the
microphone pre-amp.
Содержание ZLX Series
Страница 1: ...ZLX Powered Loudspeaker Series ZLX 12BT US ZLX 15BT US ZLX 12BT EU ZLX 15BT EU en Installation manual...
Страница 2: ......
Страница 35: ......