12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Bosch Communications Systems
03/2008
Part Number LIT000069 Rev B
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other Internatonal locations. For customer orders, Contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 887-9212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at:
866/78AUDIO
Specifications subject to change without notice.
Electro-Voice
®
Attaching Safety Point to Speaker
(PX1122M and PX1152M)
For PX1122M and PX1152M Only: Remove the M10
flat head bolt from the loudspeaker, and replace with
a forged steel shoulder eyebolt with a minimum safe
working load of 100 lbs. Attach a safety cable from the
eyebolt to the truss. The eyebolt and cable are not in-
cluded with the accessory and are the responsibility of
the user. The cable should have no more than 2" of
slack (see Figure 7).
Attaching Safety Point to Speaker (Plasma P1)
For Plasma P1 Only: Attach a single stud anchor fitting
with a minimum safe working load limit of 100 lbs. to the
top L-track. Connect a cable between the anchor fitting
and truss with a maximum of 2" of slack. The anchor fit-
ting and cable are not included with the accessory and
are the responsibility of the user (see Figure 8).
Attaching Safety Point to Speaker (ZX Series)
For ZX Series Only: Attach a single stud anchor fitting
with a minimum safe working load limit of 100 lbs. to the
top L-track. Connect a cable between the anchor fitting
and truss with a maximum of 2" of slack. The anchor fit-
ting and cable are not included with the accessory and
are the responsibility of the user (see Figure 9).
Figure 7:
Attaching a Safety Point to a Phoenix
Series Loudspeaker
(VSA-1 Not Shown for Clarity)
Figure 8:
Attaching a Safety Point to a Plasma
P1 Loudspeaker
(VSA-1 Not Shown for Clarity)
Figure 9:
Attaching a Safety Point to a ZX
Series Loudspeaker
(VSA-1 Not Shown for Clarity)
Truss
Eyebolt
PX1122M or
PX1152M
Loudspeaker
Truss
Single-Stud
Anchor
Fitting
Plasma P1
Loudspeaker
Truss
Single-Stud
Anchor
Fitting
ZX Series
Loudspeaker
HA-3 or HA-5
Adaptor
