RE97-2Tx
Low Profile, Head-worn, Omni-directional, Condenser Microphone
Application Notes (Continued):
Adjusting the Microphone Boom:
The three-pronged snap on the strain relief at the
back end of the microphone boom can be placed
anywhere along the headband. Simply pull the
strain relief off of the headband, move the boom
and microphone to the desired position, and snap
the strain relief back on to the headband (Figure 6).
A slight bend can be put into the boom for ideal
placement of the microphone near the corner of the
mouth.
Note: Although the microphone boom is
designed to be malleable, permanent damage to
the microphone may result if bent at an angle
exceeding 45 degrees.
To adjust, gently bend the
boom a small amount at multiple locations or
around a curved object rather than bending it
sharply at one point (Figure 7a and Figure 7b).
Figure 6. Adjusting the Microphone Boom
Figure 7a. Do Not Bend Mic Boom Sharply
Figure 7b. Shaping the Mic Boom Gently
Figure 8. Using the Clothing Clip
Using the Clothing Clip:
The microphone cable should be routed behind the
neck of the user and secured in place with the
supplied clothing clip. Allow some slack in the cable
to enable the user’s head complete range of motion
in both directions without pulling the cable from the
clothing clip (Figure 8).
4
