Electro-Voice EVID-P6.2B, Руководство по установке

Страница: 13 / 20

EVID Pendant Speaker Wiring | en 13
Electro-Voice Installation manual 2018.09 | 03 | F.01U.358.439
4 Wiring
It is recommended to hang the speaker before making the wire connections.
4.1 Step 1 – Attach wiring to the terminal connector
Insert the bare end of wire into the appropriate connector terminals and screw down the hold-
down screw until tight, using a small screwdriver.
INSTALLATION NOTE: CONNECTOR
Figure 4.1: Tighten with screwdriver
WIRING GUIDELINES
The input connector’s four terminals are numbered and marked on the connector. Pins 1 and
2 are positive (+); pins 3 and 4 are negative (-).
Note: Pin 1 is connected to Pin 2 and Pin 3 is connected to Pin 4 inside the speaker. Pins 1
and 4 are used as daisy-chain connections to other loudspeakers.
There are two possible layouts for wiring a group of speakers; wiring in parallel or Daisy-
Chaining.
Wiring in parallel
Connect the wire pair of the subsequent speaker to pins 2 and 3. When one input connector is
removed, subsequent speakers will remain connected.
From amplifier or
previous speaker To next speaker
Figure 4.2: Parallel wiring
Daisy-Chaining
Connect the wire pair of the subsequent speaker to pins 1 and 4. When one input connector is
removed, subsequent speakers will also be disconnected.
From amplifier or
previous speaker To next speaker
Figure 4.3: Daisy-Chain wiring