Electro-Voice EVID FM4.2, Руководство пользователя

Страница: 8 / 16

Installation and Wiring
INSTALLATION NOTE: CONTROLLING VIBRATION
Because of their high performance, EVID FM Series loudspeakers can
generate substantial vibration, which can cause buzzing in loose sections
of the wall, depending on the character of the wall and related compo-
nents.
Step 1: Cut the Hole
For sheetrock walls, cut out the hole by tracing the cardboard template
(See Figure 4). If the wire has been pre-installed, pull the wiring through
the cutout hole.
Step 2: Attach Wiring to the Terminal Connector
Insert the bare end of wire into the appropriate connector terminals as
described below and screw down the hold-down screw until tight, using a
small screwdriver.
Figure 4:
Cutting Hole
Figure 5:
Tighten with Screwdriver
6 EVID™ FM Series Installation and Operation Manual
Screwdriver
INSTALLATION NOTE: CONNECTOR WIRING GUIDELINES
The input connector’s 4 terminals are numbered and marked on the con-
nector. Pins 1 and 2 are positive (+); pins 3 and 4 are negative (–). (Pin 1
is connected to Pin 2 and Pin 3 is connected to Pin 4 inside the speaker.)
Pins 1 and 4 are used as daisy-chain connections to other loudspeakers.