Page
4
of
15
Never use the mains plug or an external timer as a
switch to start and stop the air conditioning unit. Use
the provided ON/OFF button located on the control
panel.
Always place the unit on a dry and stable surface.
The appliance should not be installed in laundry or wet
rooms
The appliance must be placed in a room without
sources of ignition (for example: open flames, an
operating gas appliance or an operating electric heater).
R290 refrigerant gas complies with European
environmental directives.
R290 has a low GWP (Global Warming Potential) of 3.
The air conditioner contains about 215 g of R290 refrigerant gas.
Do not use or store in an unventilated space with an area smaller than 10.3m
2
per
unit. The room must be such as to prevent stagnation of possible leaks of
refrigerant gas as there could be a danger of fire or explosion hazard should the
refrigerant come into contact with electric heaters, stoves or other sources of
ignition.
If the appliance is installed, used or stored in an unventilated room, the room must
be such as to prevent stagnation of possible leaks of refrigerant gas as there could
be a danger of fire or explosion should the refrigerant come into contact with
electric heaters, stoves or other sources of ignition.
Refrigerant gas may be odourless.
Do not use the product and contact the retailer for advice, if damage has occurred
to the unit which may have compromised the refrigerant system.
Any repairs or maintenance must only be carried out on the unit by a suitably
qualified engineer. Before opening and servicing the unit the authorized
engineer must be in possession of a copy of the manufacturer’s service manual
and must follow the safety information contained within it to ensure all hazards are
minimized.
The refrigerant system should not be perforated or punctured.
Energy Saving and Unit Safety Protection Tips
Do not cover or restrict the airflow from the outlet or inlet grills.
For maximum performance the air conditioner should be situated at least 50cm
from the walls or other objects.
Keep the filters clean. Under normal conditions, filters should only need
cleaning once every three weeks (approximately). Since the filters remove
airborne particles, more frequent cleaning maybe necessary, depending on the
air quality.
For the initial start-up set the fan speed to maximum and the thermostat to 4-5
degrees lower than the current temperature. After, set the fan switch to low and
set the thermostat to your desired setting.
To protect the unit we recommend the unit should only be used when the room
temperature is between 7°C and 35°C. If the temperature is below this use
electrical heating to raise the temperature above 10⁰C before starting the unit.
