Page
10
of
15
SLEEP MODE
Press the
Sleep
button to enter sleep mode, the default fan speed is low and the Sleep
mode indicator led will illuminate.
When the sleep mode is turned on:
After one hour the set temperature will increase by 1 degree Celsius, after another hour
the set temperature will increase by another degree, and will then remain set at that
temperature.
Please note:
Sleep mode cannot be used in dry and fan modes.
If internal tank becomes full, the machine will turn off and sleep mode will be
cancelled.
TIMER BUTTON
The in-built timer will allow you to set the unit to turn on or turn off after a set period of
time, Please note only one timer can be used at any time.
ON TIMER
– The timer will turn on the unit automatically after the time set has elapsed.
1.
With the unit turned off, press the TIMER button, then set the number of hours’ time
you desire the unit to start by using the UP and DOWN buttons.
2.
Once the set time has elapsed, the unit will turn on automatically.
3.
Press the POWER button before the time has elapsed and the unit will turn on as
normal and the timer will be cancelled
4.
The function and fan speed can be set whilst setting the timer.
OFF TIMER
– The timer will turn off the unit automatically after the time set has elapsed.
1.
While the unit is operating, press the TIMER button then set the number of hours’
time you desire the unit to stop by using the UP and DOWN buttons.
2.
Once the set time has elapsed, the unit will turn off automatically.
3.
Press the POWER button before the time has elapsed, the setting time will be
cancelled and the unit will turn off.
TANK FULL INDICATOR
When illuminated this indicates that the internal water tank is full and requires emptying,
following the information provided in the water drainage section.
LED DISPLAY
The display indicates the current target temperature or the remaining timer settings. When
the set temperature or the timer is adjusted, the new setting is shown.
The display is also used to show error codes. Should a fault occur, see ERROR CODES.
CHANGE BETWEEN FARENHEIT AND CELCIUS
To change the unit of measurement shown on the display, press both the UP and DOWN
buttons at the same time
