3
INSTALLATION
Use the screws provided (M4x25) to fix the controller backing plate onto the
wall, ensuring that it is securely connected before proceeding. Depending on the
type of wall, suitable fixings should be purchased.
NOTE
: Do not overtighten the screws, as this may cause the backing plate to
distort or break.
Remove the wired controller from the backing plate using
a flat headed screwdriver in the gap between the backing
plate and the controller. Once the two parts are
separated, the remainder can be unclipped.
Pass the signal wire through the opening in the rear of the
backing plate, ensuring it is positioned so it will not be
trapped or damaged during installation. Allow enough cable
to pass through for ease of installation and future
maintenance.
Connect the signal wire between the wired controller
and the air conditioner. The cable with the connector
for the controller is fixed to the rear of the air
conditioner.
If the signal cable provided is too short it can
be replaced with suitable 5-core shielded
cable up to a maximum length of 20m.