2
SAFETY WARNINGS
•
Before attempting installation, the Installation Manual must be fully read and
understood.
•
When choosing a suitable position for installation, consideration should be
made to avoid external influences which may damage the unit, shorten its life,
or make the unit unsafe. Places to avoid include:
1.
Areas in the vicinity of flammable gasses.
2.
Areas where the unit may be splashed by liquids or oils.
3.
Areas likely to experience extremes of temperature.
4.
Areas exposed to high levels of electromagnetic radiation.
5.
Any place with high levels of humidity.
•
This unit should be installed by a competent person. If unsure, professional
advice should be sought.
•
Do not operate this device with wet hands or allow it to come into contact with
water. An electric shock or short circuit may occur.
•
Do not attempt to modify or repair the unit. This must only be attempted by a
qualified engineer under the instruction of the manufacturer.
•
Ensure that the power supply is disconnected from the unit before attempting
to open the shell.
•
Ensure the interconnecting cables are suitably rated for the application and that
they are routed in a way to prevent damage during installation and use.
•
This unit is only designed for use with the air conditioners listed. Do not attempt
installation with any other equipment without confirmation from the
manufacturer.
•
Ensure that any fixings used to wall mount the unit are suitable for the type of
wall.
•
Before drilling holes, care should be taken to avoid any hidden pipework or
cables. If in doubt professional advice should be sought.
•
Maintenance and repair of this product should only be carried out by a qualified
professional.
•
Keep this manual safe for future reference or for use by a third party.
•
The correct use of this product is detailed in this manual. Failure to follow the
instructions may result in damage or injury.
•
All installation and service carried out on the appliance must conform to the
corresponding local standards, laws and regulations.
•
Due to continuous product development, the product may vary slightly from the
illustrations provided.
•
The length of the supplied cable is 2.5m if this needs to be extended, it must be
done so by a qualified engineer or a suitably competent person.