10
OPERATING INSTRUCTIONS
BEFORE FIRST USE AND AFTER EVERY GAS CYLINDER CHANGE, THE GAS DELIVERY SYSTEM MUST BE
PURGED OF AIR BEFORE IGNITING! TO DO THIS, TURN THE CONTROL DIAL ANTI-CLOCKWISE TO THE
PILOT SETTING. PRESS THE DIAL IN AND HOLD FOR 1 MINUTE BEFORE ATTEMPTING IGNITION.
TO LIGHT THE PILOT
⚫
Check all connections prior to each use.
⚫
Turn on gas supply at the bottle.
⚫
Press and turn the control dial anti-clockwise to the
PILOT
position, see right photo.
⚫
Hold the dial down while pressing the
IGNITION
button
repeatedly until the pilot flame is lit, then continue to hold the
dial down for 10 seconds until the pilot remains lit after
releasing dial.
⚫
If pilot fails to ignite, press and turn the dial clockwise to the
OFF
position before repeating.
TO LIGHT THE PATIO HEATER
•
Before lighting the patio heater, the pilot light should be lit with the dial set to
PILOT
.
•
Press the dial and turn anti-clockwise to the
HIGH
position.
•
When the mesh glows, the dial can be turned clockwise to the desired setting.
Note: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn
the control dial to the pilot position. Then turn the dial to the level of heat desired.
RE-LIGHTING
•
Turn Control Dial to OFF.
•
Wait at least 5 minutes, to let gas dissipate, before attempting to re-light the pilot.
•
Repeat the “Lighting” steps.
AFTER USE
•
Press the dial down & turn clockwise to the
OFF
position
•
Turn off the valve on the gas cylinder or regulator after use.
•
Disconnect the gas bottle and allow this appliance to cool before moving the appliance.
Note: After use, some discoloration of the emitter screen is normal. Close regulator after use, allow the
appliance to cool before moving.
PILOT
IGNITION
OFF
HIGH
LOW
